For my Kobo I’ve mostly used Anna’s Archive and then converted epub from there into kepub format with Calibre; just need to rename the file to the epub file extension afterward (I usually keep both like My book.kepub.epub for my own reference).

Edit: MyAnonaMouse is indeed a great community as others have said though I found their selection to not be as good though that might be biased to the topics I prefer to read.

Same for me: I read on both laptop and phone so sync is important

I’ve settled into a Kobo for various reasons and tend to read while pacing my basement where it’s quiet and a bit cooler.

We make these often; kiddos love them

Update: wire arrived today and it was NOT a match. The X Limit Switch wire has a white label with an X and while 1 end is correct the other is wrong. Creality support did eventually get back with me and said it was the cutter detection cable with SKU 3103110734 so guess I’m set back another 3 weeks ordering the other wire variations from DREMC. In hind sight I should have gone ahead and ordered 1 of each to be sure; oh well.

Creality store support said they don’t have the part and directed to main Creality support email

Creality support email said to try Amazon, Alibaba or Aliexpress - no luck on any of those

Ordered a replacement from a site in Australia (only place I’ve found so far that carries it) and will likely attempt to repair the wire while I wait for it to arrive

I think that’s the one! Mine even has the “D” printed on the white sleeve like that one has. Thank you!!

Creality Hi Series Filament/Cutter Sensor/X Limit Switch Wiring
SKU: 3103080144
https://store.dremc.com.au/en-us/products/creality-hi-series-filament-sensor-wiring?variant=46843602665641

This is the only online store I’ve found so far that carries it. Will wait for support email to reply to see if they’ll supply it.

SEE UPDATE IN MAIN POST

Ditto on Jellyfin and games. We’ve had a lot of fun with Luanti and Super Tux Kart.

Yep, learning an instrument would be mine as well

These are the ones I have:

https://a.co/d/03CQzwDh

I’m a khakis guy and recently switched to suspenders, specifically the kind meant to be worn under the shirt, and am loving the change. Much more comfortable IMO. I wear polo shirts untucked and people tell me they’d never know I wore them until pointed out.

Tailscale runs on Wiregaurd which is ridiculously fast. Also helps we’re located physically near each other on fiber from the same company so less network hops.

Nope! We use it for Jellyfin too which also works great 😸

Gaming with friends and family over Tailscale on my servers; it just works

I am also a developer and agree entirely.

Asking for advice, examples or the occasional boilerplate is at most how I use AI and certainly not integrated directly into my IDE.

We have Jellyfin with remote streaming as well though we use Tailscale for that and works great

Check out the Fluidum comic on Webtoons

For Lemmy I just chose a larger instance and went with it. I’ve considered moving to one more aligned with my interests though hasn’t been much reason to yet.

For Mastodon I went with Fosstodon precisely for my interests as I can better enjoy the local feed.

Ado, especially Elf

Love BAR! I usually play with my son’s against AI or watch pro streams. Such a great game.