Understood. Thanks for all your help. I’ll try to pull out the flash carefully as you said. And thanks for the suggestion about the external flash, I’ll check the one from Yongnuo that you’ve said.

Yeah, sorry.

The error says “Impossible take out the embedded flash. Turn off and turn on again the camera.”

Thanks for your answer and help! I will do only simple models, little characters, nothing complex with blender.

Thanks for your answer. It has a Intel UHD Graphics 620 GPU.

Thank you very much for your answer.

Really thank you! So Blender + Cura. I will start to learn Blender, thanks!

Thank you very much for all the indications. I will follow everything of what you have said!

Ok, thank you very much. These prints will be used only to decore cakes and those cakes are only for photos and not meant to be eaten. So I will check Blender, do you have any suggestion from where to start (any YouTube channel, books, courses or guides)? And then Cura. Thank you again!

Thank you! I would like to print little cartoon characters for decorative cakes. I can’t find them on the web so I was thinking that I could make them.

Thanks for the suggestion. I’ll look into Tinkercad for starting.

Actually I don’t have any printer and I really don’t know where to start looking at. Thanks again

By safe I mean about privacy, if there’s possibility that someone can “intercept” the photos of the child. Sorry if I didn’t explain it well

Thanks for tour answer :)

Wow! I’ll try everything you’ve said! Thanks you very much!

Thanks!

Thanks, I’ll check that.

Thank you very much!

I didn’t know this, thanks!

Thanks for the help :)

Thank you very much!

Thank you so much! I will try it, thanks!