[ISSUE] Layer is closer at one end than other - eviltoast

My prints come out very well but I’m noticing on larger prints that one corner of my bed prints tighter than the opposite. What’s causing this?

Printing on an Ender 3 Pro with upgraded metal extruder, beefier bed springs and metal levelers, and upgraded hot end. Not direct drive yet and no auto bed leveling.

  • MinorLaceration@lemmy.worldEnglish
    2·
    8 months ago

    Sorry, I’m not able to access my PC for a while so I can’t look. All I did was google something like ender 3v2 bl touch firmware and went from there.

    • CaptKoala@lemmy.mlEnglish
      1·
      8 months ago

      All goods matey, I have yet to do the sensor, I was looking into custom firmwares the other night and found some cool stuff, however my ender refused to accept any updates to it’s standard firmware, so I figured I’d ask here.