![[ISSUE] Layer is closer at one end than other](https://lemmy.world/pictrs/image/183a53d9-38c3-42d1-8130-a10f40e00b1d.jpeg){kind=link}
My prints come out very well but I’m noticing on larger prints that one corner of my bed prints tighter than the opposite. What’s causing this?
Printing on an Ender 3 Pro with upgraded metal extruder, beefier bed springs and metal levelers, and upgraded hot end. Not direct drive yet and no auto bed leveling.
If one corner is tighter that would seem to indicate a heigh spot on ur bed hence the extrusion is being squished into a thinner layer