storing of filamenter bewteen prints - eviltoast

How long do you have filament sitting “in the open”? I mostly print with a single filament roll at a time, and just leave it on the printer. A 1kg roll lasts me several weeks. For long time storage I keep it in an air tight box with disiccant pouches.

But how long can I let it sit before I should start storing it with disiccant and/or drying the filament before use?

  • dirtdigger@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    edit-2
    11 months ago

    Depends on where you live. I live in a desert where the humidity is often <10% and have left PETG and PLA rolls out for several weeks at a time with no issues. With nylons I’ve been a bit more careful, though I’m not sure I need to be.

    What kind of climate do you live in?

    • DreadPotato@sopuli.xyzOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      edit-2
      11 months ago

      Fairly humid Scandinavian climate, 60-80% humidity depending on season, inside its usually around 50% though.

      • paf@jlai.lu
        link
        fedilink
        English
        arrow-up
        1
        ·
        11 months ago

        In winter, you won’t need to care much as heating will help to keep low humidity, the rest of the year, I would say you can keep pla roll out about a week before storing it but personally (living in 60-85% humidity climate), I just let it out so I’m ready to print. If I start a print after about a week, stringing will likely appear but if stays out for about a month, filament will become brittle.