Klipper vs Marlin - eviltoast

I actually have Marlin + Octoprint but found out recently that Klipper exist. I read everywhere that Klipper is better but I don’t really get why. I understand that Klipper use raspberry as powerfull calculator instead of the STM32 of the printer, but octoprint is used to send Gcode to Marlin too… So what’s the really difference please?

Edit : I don’t understand how Klipper or Marlin can give better results when gcode and instructions are generated by Cura

    • LazaroFilm@artemis.camp
      2·
      1 year ago

      You’re welcome. There is a lot more than that even. When you start digging through, Klipper allows you so much control. You can even have your printer run shell commands (deactivated by default because it so powerful, it can be dangerous if you don’t know what you’re doing)

      You can control RGB LEDs and more. You can also connect many arduino isntesad of just one

      • p1mrx@lemmy.worldEnglish
        7·
        1 year ago

        You can even have your printer run shell commands

        I briefly considered using Klipper to make a clock that prints 1 layer per minute, but gave up after realizing it’d be unreadable after the first hour:

        • LazaroFilm@artemis.camp
          2·
          1 year ago

          You could use multi material with color change on the hour. You don’t even need to flush the nozzle you could have the color gradually change throughout the layer, or print a handful of perimeters only between each hour.
          You could have the first sector to be filled with a hole in the shape of the hour number. Then on the hour change print a couple of top layers covering the hole and print the next layer with the next number as a hole. It’s a really cool idea, as long as you don’t use a heated bed and manage your nozzle heating properly to keep your electric bill manageable. Also you definitely want low print speed and some TMC drivers hehe.

        • CmdrShepard@lemmy.oneEnglish
          1·
          1 year ago

          Well if your clock business doesn’t take off you could always consider the wagon wheel or bicycle business!

      • nosnahc@lemmy.worldOPEnglish
        2·
        1 year ago

        First of all, I need to fond out how to control my tasmota switch to turn on/off my printer and my led…