Triple trouble - emitters not equally bright - eviltoast

Hi All,

I recently built my first 2x S2+ triples with KD SST20 MCPCBs and Convoy 5A drivers. On one of them I noticed, when at 1%, 1 emitter is noticeably dimmer than the other 2. My second triple I changed the sense resistor to provide slightly more amps and that one is fine.

Anyone experienced this? Could it be a bad mcpcb, driver/level issue?

  • Adair21@lemmy.worldM
    link
    fedilink
    English
    arrow-up
    0
    ·
    1 year ago

    It could be a bad reflow, but it’s common for one to be brighter at moonlight because of forward voltage tolerances

    • dmenezes@lemmy.world
      link
      fedilink
      English
      arrow-up
      0
      ·
      1 year ago

      common for one to be brighter at moonlight because of forward voltage tolerances

      Interesting, I would never have guessed. Glad my TS10 doesn’t show that even at level 1 brightness.

      • toadiesss@lemmy.worldOP
        link
        fedilink
        English
        arrow-up
        1
        ·
        edit-2
        1 year ago

        Experience like this is why this community rocks. Intrigued by Adair21’s answer, I read around the web to understand better - I didn’t realise there could be so much tolerance in LED forward voltages!

        As a result, when in parallel/at the same drive voltage, different currents drawn = different relative brightness. Outside of independent resistors, you’d need to get lucky with matched emitter tolerances or just run above moonlight so that the difference is less noticeable.

        Maybe it’s a reflection of the cost of the KD boards?