Stepper motor noise at idle - eviltoast

Hey guys, I am very new to this and currently have a neptune 3 plus sitting at home.

I tried a few test prints which went completely fine. But now I notice that one of the stepper motors is making a lot of noise (and vibrating) when it is idle. Is this an issue and how can I deal with it if it is one?

  • Vathsade@lemmy.ca
    link
    fedilink
    English
    arrow-up
    0
    ·
    1 year ago

    Can you describe the noise? Is it a high pitch whine, or a grinding sound?

    It could be loose cable/connector for the stepper motor, as that can cause all sorts of strange sounds (usually of the grinding type).

    If it’s more a constant high pitch sound, it’s likely the motors in use since they draw a lot of current to hold position (steppers work funny that way). This can be ignored safely, or reduce the motor peak amps to the motor to quiet the whine a bit (this usually involves modifying the firmware, and can be a bit more difficult sometimes.

    Good luck

    • MacaroniLove@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      To add a little bit to this, check if the motor gets hot. If it’s not hot then you probably don’t need to worry.