Anyone have any solutions for this issue? You’d think it would just bridge over the entire hole, don’t know why it’s doing this. We’re at 195mm height here and I’d rather not run a support the entire height of the model just for this little nub.
Using version 2.6.1
Edit: Model in question https://www.thingiverse.com/thing:5551428. Not my own, but getting some fun things printed for the Spooky season
It looks like you already found a solution, but to be honest: I wanted to help you out, but the model is just 100mm high. If you are at 195mm height, I couldn’t even reproduce your issue. I looked around to find a hole similar to the screenshot, but haven’t found it. Looked through the layers but haven’t found any of mid-air prints :(
Printed at 200% (So 200mm tall in total). 195mm was just that layer’s height. Who knows what little setting was making it be like that.